![]() ![]() Tip: some tapes are marked on the bottom for the length of the tape “housing”, for lack of better terms. But if you’re pulling against something the width of this will throw your measurements off. If you’re butting up against something, it pushes the tip in so it gives you an accurate measurement. You can see three rivets or two rivets hold on to this on your tape measure and they’re all Wiggly (little notch). So every tape measure has a little hole in the front the sole purpose of that hole is to be able to easily hook it on a nail and pull the tape long distances. ![]() Why does a tape measure have a hole at the end?ĭid you know that all tape measures include a little notch at the end that may catch into a nail or screw? If no one is available to hold the other end of the tape measure, hammer a nail into the ground and hook the tape measure onto it. Why is there slack at the end of a tape measure? Tip to measure accuracy It takes far less time to measure twice than it does to start over once an error has been made in a project. Step 6: Take accurate measurements and confirm them. Instead, you would say “23 millimeters” out loud. “2 centimeters and 3 millimeters” is not acceptable. Step 5: Using feet, inches, and fractions of inches, write down your measurement.Įxpress metric measurements with the tiniest divisions possible. Meters, centimeters, and millimeters are represented by the marks.Ī meter has 100 centimeters and a centimeter has 10 millimeters. Step 4: Take note of the tape measure’s metric side. These markers are useful for many DIY projects that require measurements on 16-inch centers. Step 3 : Check every 16 inches for distinctive marks. The majority of tape measures have 16ths-inch increments.Īs a result, there are 15 lines, each measuring 1/16 of an inch, between the inch markers. Step 2: Determine the shorter, in-between fractions-of-an-inch markers that are placed between the inch marks. The red numerals represent feet, whereas the black numbers are inches. Classes include professionally produced videos taught by practicing craftspeople, and supplementary downloads like quizzes, blueprints, and other materials to help you master the skills.Step 1: Identify the markings on the tape measure’s top. MT Copeland offers video-based online classes that give you a foundation in construction fundamentals with real-world applications. If you prefer to mark with your right hand and hold your tape measure with your left hand, you can special order a left handed tool.
0 Comments
Leave a Reply. |